Bush Hog M146 - Manual (Page 13)

C. Check that lift cylinders are fully retracted.
Figure 2-3. Then drive tractor forward. Use bucket
cylinders to position height of outer pedestal top pin.
Figure 2-4.
Figure 2-4 Outer Pedestal Top Pin
Clamp And Pins In Stored Position
D. Align outer pedestal top pin with mounting
bracket guide post on both sides.(Figures 2-2, & 2-4)
Make sure loader is centered right to left on both
brackets.
E. Extend the bucket cylinders to lower the
pedestal top pins into mounting bracket receivers on
both sides. Figure 2-5
Figure 2-5 Loader Installed With All
Pins In Working Position
Figure 2-7
Clamp Installed In
Working Position
11
F. Extend lift cylinders slowly making sure loader is
seated completely in mounting bracket top and bot-
tom receivers. Retract bucket cylinder until bucket is
approximately 1/2” off ground.
G. Remove lockwasher, quick attach nut, and
self storing tool from holder. Remove quick pin and
clamp from storage position. Place clamp and quick
pin in working position. Install quick attach nut and
lockwasher to eyebolt using self storing tool. Store
self storing tool in holder. Figures 2-6 & 2-7.
Tightening Quick Attach Nut
Using Self Storing Tool
Figure 2-6 Eyebolt
Quick Attach Nut Lockwasher