Control company – Control Company 4135 TWO-CHANNEL THERMOMETER User Manual
Page 2
Traceable
®
is a registered trademark of Control Company ©2008 Control Company. 92-4135-00 Rev. 2 052008
ACCESSORIES
Control Cat. No. 4014—
Stainless Steel Triple Purpose Probe, probe diameter
1
/
8
" (0.32cm), probe length 6"
(15.2cm), overall length 9" (22.9cm), cable length 50" (127cm).
Control Cat. No. 4008—
Surface Probe, flat disk on end has a diameter of 0.39" (1cm), overall length 9"
(23cm), cable length 36" (91.4cm).
Control Cat. No. 4028—
Ultra-fast response, naked bead thermocouple. (identical to probe supplied with unit)
cable length 48" (122cm).
Control Cat. No. 8039—
Low-Temperature Probe - Stainless-steel with handle; triple purpose (liquids, air/gas,
and semi-solids), Dimensions: diameter 0.17 inch; stem length 12 inches; overall
length 17 inches.
Control Cat. No. 8613—
High-Temperature Probe - Ten-foot-long 0.19-inch diameter braided metal wire cable
with smooth tip measures -73 to 982°C continuous or 1093°C short-term use.
DISPLAY MESSAGES:
OL
indicates that no probe is present.
indicates that the battery is low and needs replacement (see battery
replacement).
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, please replace the
battery with a new high quality battery (see “Battery Replacement” section). Low
battery power can occasionally cause any number of “apparent” operational difficulties.
Replacing the battery with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT:
A "
" symbol will appear on the LCD display when the battery needs replacement.
Before replacing the battery turn the unit off and unplug the probes. Slide the unit out
of its rubberized protective casing. Remove the three screws from the back of the
meter and lift off the front of the case. Remove the exhausted battery and replace it
with a new 9 volt alkaline battery. Replace the front of the meter, insert the screws and
slide the unit back into its rubberized casing.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.