CounterPath Bria 2.5 Windows User Guide - Manual (Page 19)

Bria 2.5 for Windows User Guide
15
Placing another Call
To place a new call (without hanging up on the current call), click the Start another Call button. In the Current
Calls bar, a tab appears for each separate call.
Hiding your Identity
You can hide your identity on a call, so that the other person will not see your ID on their phone.
Click Options > Hide my Number for this Call. appears on the Call control bar for this call. Place the call in
the usual way.
Your identity is hidden only for this call.
Which Account Is Used?
When placing an outgoing call, you can explicitly specify the account to use for that call. Click the Account
Selection menu and select the desired account.
Once the call is placed, this menu always reverts back to “Auto”.
If You Do not Select an Account – Auto Account
If you have more than one account enabled and if you do not select the account, Bria selects the account to use
to place the call as follows:
• If a dial plan exists for any account, Bria runs through the dial plans to determine if the dialed number
matches any of these plans. If a match is found, the account that the dial plan belongs to is used. See “Dial
Plan” on page 80.
• If there is no match on any dial plans or if no dial plans are defined, then the default account is used. The
default account is the account listed first in the Account Settings window (page 64).
Ending a Call
Click the red End call button on the Call panel. Details of the call remain on the call display for a few seconds.