Dakota Ultrasonics DFX-7 plus MANUAL1 - Manual (Page 58)

Dakota Ultrasonics
54
4) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
5) Repeat steps 3 & 4 until the thickness is correctly displayed.
6) Press the OK key to set the THICKNESS and return to the menu screen, or
ESC to cancel entering the THICKNESS.
Note: Thickness is used to calculate the depth.
Transducer Angle
1) Press the UP and DOWN arrow keys until ANGLE is highlighted, followed
by pressing the LEFT and RIGHT arrow keys to scroll the value. When the
correct angle is displayed, proceed to the next setting.
2) Alternatively, press the ENTER key to display the Digits Edit Box.
3) Press the UP and DOWN arrow keys to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
5) Repeat steps 3 & 4 until the angle is correctly displayed.
6) Press the OK key to set the ANGLE and return to the menu screen, or ESC
to cancel entering the ANGLE.
X-Offset
1) Press the UP and DOWN arrow keys until X-OFFSET is highlighted,
followed by pressing the LEFT and RIGHT arrow keys to scroll the value.
When the correct X-Offset is displayed, proceed to the next setting.
2) Alternatively, press the ENTER key to display the Digits Edit Box.
3) Press the UP and DOWN arrow keys to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
5) Repeat steps 3 & 4 until the X-Offset is correctly displayed.