Danuser 2035 Round - Manual (Page 11)

Assembly &
Installation
Bolt-on Bucket Mount
Drive unit and auger
exploded views and part lists
are detailed on separate pages
in this manual.
Because of the weight of
some components, and
because some
components are difficult
to balance, two people are
required for safe
assembly and installation
of this equipment.
Personal protection
equipment including hard
hat, safety glasses, safety
shoes, and gloves are
recommended during
assembly, installation,
operation, maintenance,
removal, or movement of
the earth auger. Do not
allow long hair, loose
fitting clothing, or jewelry
to be around moving
parts.
STEP 1: Drill four holes in the loader bucket to accommodate bucket mount assembly (1).
STEP 2: Bolt mount assembly to the left or right outside vertical surface of the bucket.
(See figure above.) Hardware to attach the mount assembly is not included in the
kit. You will need the following:
4 bolts (1/2" diameter, Grade 5 or greater)
4 lock washers (1/2")
4 nuts (1/2")
STEP 3: Attach knuckle assembly (2) to the drive unit (3) using pin (4). Secure pin (4)
with klik pins (5).
STEP 4: Attach knuckle assembly/drive unit to mount assembly (1) using pin (6). Secure
pin (6) with bolt (7) and nut (8).
= Safety Sign
Location
11
Consideration must be given to the installation location of bolt-on bucket mount
kit. The drive unit should be able to swing during normal operation without
interference from the bucket. The bucket must be constructed with sufficient
strength to safely handle the load forces generated during digging. Position drive
unit to allow space for the hydraulic hose connections and routing of the hoses.
REF. NO. PART NO. DESCRIPTION QTY.
1 9591B Bucket Mount Assembly 1
2 10022 Knuckle Assembly 1
3 ----- Drive Unit 1
4 10032 Pin (1-1/4” x 7-5/8”) 1
5 1600 Klik Pin 2
6 9595 Pin (1-1/4" x 6") 1
7 3041 Bolt (3/8” 16 x 3-1/2”) 1
8 2805 Self-locking Nut (3/8” 16) 1
9 10038 Special Retaining Bolt - 2" Hex 1
(3/4” 10 x 4”, Gr. 8, 3/4” of thread)
10039 Special Retaining Bolt - 2-9/16" Rd.
(7/8” 9 x 4-1/4”, Gr. 8, 3/4” of thread)
10 10041 Nut (3/4” 10) - 2" Hex 1
10042 Nut (7/8” 9) - 2-9/16" Rd.
1
2
3
4
5
10
9
6
7
8