Black & Decker Dustbuster Flexi PD1200 - Manual (Page 6)

6
The appliance/tool/battery must be placed in a well
ventilated area when charging.
Electrical safety
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
Features
This appliance includes some or all of the following features.
1. On/off power switch
2. Removable hose/handle
3. Locking ring
4. Hose
5. Filter cleaning wheel
6. Charging inlet
7. Transparent door
8. LED charging indicator
9. Door latch
10. 2-in-1 combi nozzle accessory
11. Accessory clip
The following accessories are only available with model
number PD1200 (fig. A & B):
12. Accessory caddy
13. Powered brush head
14. Crevice tool
The powered brush head is not included with all models.
Assembly
Mounting accessories (fig. A, B & C)
The 2-in-1 combi nozzle (10) has a brush that can be folded
forward for dusting and upholstery cleaning.
The crevice tool (14) allows for vacuuming in narrow and
hard to-reach places.
The powered brush head (13) has its own rechargeable
batteries and is charged separately from the appliance, refer
to “Charging the battery” section.

To fit an accessory press the accessory clip (11) and
slide the accessory onto the handle (2).

To remove an accessory, press the accessory clip (11)
and remove the accessory.
The handle (2) can be removed from the hose (4) allowing
the accessories to be connected directly to the hose cuff (18)
when required. To remove the handle:

Unclip the handle (2) from the appliance.

Rotate the locking ring (3) anti-clockwise to release the
clips.

Pull the hose (4) away from the handle (2).

Fit the accessory directly to the hose cuff (18).
To refit the handle:

Remove the accessory from the hose.

Push the hose (4) into the handle (2). Rotate the locking
ring (3) clockwise until it clicks into place.
Fitting the accessory caddy (PD1200) (fig. D)
When not in use, accessories can be stored in the accessory
caddy (12). The accessory caddy can be removed if
necessary.

To install the accessory caddy (12) slide it onto the lugs
on the body of the appliance until it clicks into place.

To remove the accessory caddy (12) pull it away from
the base of the appliance.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:

Injuries caused by touching any rotating/moving parts.

Injuries caused when changing any parts, blades or
accessories.

Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take
regular breaks.

Impairment of hearing.

Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
This appliance is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the
ambient temperature becomes too high. As
soon as the ambient temperature has cooled
down, the charger will resume operating.
Charge only at ambient temperatures between
10°C and 40°C.
+40ºC
+10ºC