Deckorators Recessed Lighting Kit - Manual (Page 2)

• Disconnect the lights from each other and insert each fixture
into its corresponding hole by feeding the two (2) wires first
then pressing the fixture firmly into the hole so that it fits
tightly against the surface. There are two bulbs in each light.
Make sure the bulbs are consistently oriented horizontally or
vertically. Repeat this step for all eight (8) lights.
• Connect the male end of the extension wire to the "OUT"
connection of the photo sensor and the female end to the
first fixture.
• Connect the female end of the extension wire to the
first light fixture and each fixture to the next.
Step 4: Connect the photo sensor and the transformer.
• Connect the photo sensor to the transformer.
• Plug the transformer into the electrical receptacle.
How to test the system
• To test the lights during daytime, cover the photo
sensor with black tape.
• This component reacts to light conditions. It automatically
turns ON the light fixtures at dusk and turns them OFF at
dawn. It should not be exposed to any artificial light sources.
Trouble shooting
• Most problems lie within the fixture's connection or LEDs.
• Check the connection and make sure the male and female
connectors are pressing firmly together, and secure with
the screw nut.
• To check a light fixture, exchange it with another fixture
that is working.
Maintenance
• To clean, wipe with a soft, damp cloth.
• Replacement parts may be ordered by using the fixture
model number and the part's name.
The diagrams and instructions in this brochure are for illustration purposes only and are not meant to replace a licensed professional.
Any construction or use of the product must be in accordance with all local zoning and/or building codes. The consumer assumes all
risks and liability associated with the construction or use of this product. The consumer or contractor should take all necessary steps to
ensure the safety of everyone involved in the project, including, but not limited to, wearing the appropriate safety equipment. SELLER
MAKES NO WARRANTY FOR THIS PRODUCT, EITHER EXPRESS OR IMPLIED. SELLER EXPRESSLY DISCLAIMS ANY AND ALL
LIABILITY FOR DAMAGES ARISING OUT OF THE USE OR OWNERSHIP OF THE PRODUCT, INCLUDING DISCLAIMING INCIDENTAL
AND CONSEQUENTIAL DAMAGES, UNLESS OTHERWISE REQUIRED BY STATE LAW.
877.463.8379
©2010 Universal Forest Products, Inc. All rights reserved. The UL logo is a registered trademark of Underwriters Laboratories, Inc.
933 US Route 202, Greene, ME 04236 www.ufpi.com 5449_1/13
Recessed Lighting Kit Installation Instructions, continued
OUTDOOR
TRANSFORMER
TRANSFORMATEUR
POUR L’EXTÉRIEUR
ADAPTADOR DE PODER
PARA EXTERIORES
E338180