Despatch Protocol 3 Modbus Communications - Manual (Page 45)

Modbus Programming Manual A DDRESS LIST
Version 2 45
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
Get Segments Remaining - Request (to instrument)
Field Name Data Comments
(Dec) (Hex)
Command Code High Byte 83 53
Command Code Low Byte 82 52
CRC High Byte A/R A/R
CRC Low Byte A/R A/R
2.9.5.9. Edit Response Message
The instrument replies to each profile or segment creation, edit or delete message with an Edit
Response Message. The same format is used when replying to the Get Segments Remaining
request.
Edit Response Message - Response (from instrument)
Field Name Data Comments
(Dec) (Hex)
Unit Address A/R A/R The ID address of the instrument
Function Code 23 17 The multi read/write function
Byte Count 02 02
Command Response High Byte A/R A/R Two data bytes containing the Command
Response data (see below)
Command Response Low Byte A/R A/R
CRC High Byte A/R A/R
CRC Low Byte A/R A/R
Command Response Data
The data contained in the Edit Response Message returned after each profile or segment edit
message is shown below. The data seen can be an error code, the number of unused segments or
the profile number following a successful profile header creation/edit.
The error code shown will be as appropriate for the request message and instrument status.
Command Response Name Two Byte Response Description
Low Byte High Byte
Profile Number A/R A/R The number of the profile created or edited
Segments Remaining A/R A/R The number of unused segments remaining
Command Successfully 0x4F 0x4B The command requested executed without error
Command Not Recognized 0xFF 0xFF The command is not recognized
Profile Number Invalid 0xF0 0x00 The profile number specified is not available.
Profile Name Invalid 0xF0 0x01 The profile name/characters are not valid
Start Signal Invalid 0xF0 0x02 The start signal is not recognized
Start Time Invalid 0xF0 0x03 The specified time is not within range
Start Day Invalid 0xF0 0x04 The specified day is not recognized
Starting Setpoint Invalid 0xF0 0x05 The specified starting setpoint is not recognized
Profile Recovery Invalid 0xF0 0x06 The profile recovery is not recognized
Recovery Time Invalid 0xF0 0x07 The recovery time is not within limits
Abort Action Invalid 0xF0 0x08 The abort action is not recognized
Profile Cycles Invalid 0xF0 0x09 The number of profile cycles is not within limits
Segment Number Invalid 0xF0 0x0A The segment number is not valid for this profile
Segment Type Invalid 0xF0 0x0B The segment type is not recognized
Segment Info A Invalid 0xF0 0x0C The segment information A not valid for segment type
defined
Segment Info B Invalid 0xF0 0x0D The segment information B is not valid for the segment