Deutz-Fahr Agrovector 40.9 - Manual (Page 31)

Section 2 - Pre-Operation and Inspection
2-7 31200537
5. Work Lights (if equipped) - Clean and undamaged.
6. Mirrors - Clean and undamaged.
7. Cab and Electrical -
• General appearance; no visible damage.
• Frame level indicator(s) and window glass undamaged and clean.
• Gauges, switches, joystick, foot controls and horn operational.
• Check seat belt for damage, replace belt if frayed or cut webbing, damaged
buckles or loose mounting hardware.
8. Wheel Chock (if equipped) - See inspection note.
9. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
10. Rear Axle - Steer cylinders undamaged, not leaking; pivot pins secure;
hydraulic hoses undamaged, not leaking.
11. LSI Sensor - See inspection note.
12. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
13. Boom Sensor (S/N 1160005993 & After including 1160005949 & 1160005950) -
See inspection note.
14. Engine Compartment -
• Drive belts, check condition and replace as required.
• Engine mounts - See inspection note.
• Air cleaner element condition indicator, check for clogged condition. Replace
element as required.
• Main control valve - See inspection note.
• Battery cables tight, no visible damage or corrosion.
• Engine cover closed and properly secured.
15. Air Precleaner - Check and clean as required.
16. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
17. Frame Level Cylinder (if equipped) - Pins secure; hydraulic hoses undamaged,
not leaking.
18. Attachment - Properly installed, see “Attachment Installation” on page 5-9.