Eberspacher EasyStart Remote+ Operating instructions - Manual (Page 12)

12 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
3 OpeRATiOn AnD seTTing/ADjusTMenT
hEatiNg ON with shOrtprEss aNd with
sEttiNgs
press the or button to activate the mobile
unit. Following successful data transmission the start
display appears.
17:30 21 °C
shORTpRess button for less than 2 seconds; the
heATing submenu is displayed.
plEasE NOtE!
The following settings and confirmations (tempera-
ture setpoint and operating time) are always required.
seT TeMpeRATuRe seTpOinT – FOR AiR heATeRs
OnLy
if applicable, use the or button to set the
temperature setpoint.
temperature setpoint setting range:
8 °C – 36 °C in 1 °C increments,
46 °F – 97 °F in 1 °F increments.
 21 °C 
08:30
120 min
press the button to confirm the temperature
setpoint.
seTTing The OpeRATing TiMe
if necessary, use the or button to set the
operating time.
Operating time setting range:
Min 10 – max 120 min in 1 min. increments, continu-
ous heating mode is possible for air heaters.
60 min
press the button to confirm the operating time.
heater On.
60 min 21 °C
Display for air heaters in continuous heating mode
(factory setting).
21 °C
∞
plEasE NOtE!
After switching on, “On” is displayed for 2 sec and
then the remaining operating time or
for air
heaters.
During heating mode it is possible to switch to another
menu item. under the VenTiLATiOn menu item, check
the operating time and if necessary adjust.
The changed operating time is offered again the next
time the system is started.