ECOXGEAR EGBT500-501-507: ECOXBT - Manual (Page 2)

USER GUIDE
SPECIFICATIONS
Output Power: RMS 6W (3 Watt x2 speakers /4 ohms) S/N Ratio: 88db +/- 3dB
Frequency Range: 135Hz-17,000Hz Unit Size: 2.8” x 9.0” x 4.0“
Power Source: Lithium Ion 3.7V 1800mAh Battery Unit Weight: 1.5lb Storage Battery
Playtime: 10 + hours from full charge Temperature: 14°F to 131°F
Charging Options: USB to AC adapter or Computer Operating Temperature: 23°F to 104°F
Charging Time: Approximately 2 ½ hours Waterproof Rating: IPX8
MICROPHONE (MIC) & SPEAKERPHONE SYSTEM
The MIC is located on the bottom front left section of the front panel & is designed for use with the
Bluetooth speakerphone system. For best results, speak within 18” of the MIC during a call.
CAP, AUX-IN, CHARGING & USB CONNECTION
USB power & 3.5mm AUX-IN connections are under the CAP. Remove the CAP to access the connections.
IMPORTANT IF the CAP is off or not securely closed, the unit is NOT watertight. In order to ensure the unit
is watertight the back panel CAP MUST be closed securely. To securely close the back panel CAP, the CAP
MUST be inserted so that the lines on the CAP align with the back panel lines and the top of the CAP is
pushed flush with the back surface of the unit so that the gray rubber gasket around the edge of the CAP
cannot be seen.
gray rubber gasket
back panel lines
Diagram 2. Back Panel Cap & Connections
NOTE: A removable LANYARD is included with the ECOXBT and is intended to assist in avoiding misplacing the
back panel CAP. Attach one end to the nylon tab on the CAP and the other end to the handle.
AUX-IN
AUX-IN can be used as an optional connection to play an audio device using a 3.5mm audio cable connection.
CHARGING & USB CONNECTION

Charge the built-in rechargeable battery using the USB cord (included) connected to your computer OR
connected to the USB-to-AC power adapter (included) and a wall power outlet.

When connected to a power source via the USB connection on the back panel, the Battery LED on the top
panel (
refer to Diagram 1. ) will indicate the power status. IF not connected, the LED will NOT indicate the
power status. A RED LED indicates charging is in progress. A GREEN LED indicates the battery is fully charged.

The Power LED will flash 2 times quickly every 30 seconds when approx. 30 minutes of playtime remain.
NOTE: ECOXBT can charge while playing audio. Be sure to plug the USB into the desired power source prior to
playing audio or unit may need to be restarted