Elkhart Brass RAM Personal Portable Monitor - Manual (Page 11)

Page 7
operating properly, replace that specific leg assembly. If necessary a light weight
water repelling lubricant can be applied to the lock pin / spring mechanism in the
legs.
Inspect the safety strap for visible damage. The strap should inspected for fraying
and the D-Clip and Length Adjustment Ring should be inspected for physical
damage. If any of the components are damaged they need to be replaced before
the next use.
Verify that the lock pin on the valve control handle is operating properly. If any
damage or operational issue is detected, repair as necessary. If needed, a light
weight water repelling lubricant can be applied to the valve control lock pin /
spring mechanism.
Operate the valve control handle from full closed to full open in order to insure
the shut off ball is working properly and lubricated. The shut off ball can be
observed from the inlet of the RAM.
Visually inspect the RAM for any noticeable damage. Repair as needed.
Important:
If there is a question regarding any necessary repair or damage
issue, contact Elkhart Brass for assistance .
Maintenance Recommended Every Six Months
The valve ball should be inspected for physical damage and lubricated with a light
grease.
The RAM internal passage ways should be inspected for possible damage caused
by foreign objects that have carried by the water through the monitor. If damage
affecting the integrity of the monitor is noticed, contact Elkhart Brass for
assistance.
SECTION 5 – Mounting Bracket
Detail Drawing and Installation
Template
The mounting bracket is designed to accommodate
mounting locations that are close to physical
obstructions on one or the other side of the bracket such
as a truck wall or other surface mounted device on a