Elkhart Brass Cobra EXM Quick Install Guide - Manual (Page 2)

Step 4. RF Installation
Panel Mount Controller
Handheld Controller /
Docking Station
Joystick Controller OEM Interface Module Position Feedback Display
INSTALL RF MODULE INSTALL RF - OEM INSTALL RF - HANDHELD INSTALL BATTERY PACK
Step 5. Component Mounting
Step 6. Wiring
Use mounting templates found in the
instruction manual for dimensions.
DRILL MOUNT HOLES
CAN NETWORK WIRING DIAGRAM
Drill holes for CAN network and power
cables for each component.
DRILL CAN HOLES
Mount components using 10-24 x 1/2”
screws. Use Loctite 242 or equivalent.
MOUNT COMPONENTS
Install a 1A fuse (12VDC) into the positive
power lead; 0.5A fuse for 24VDC.
SUPPLY POWER - FUSE
CAN Stow Module
Connect entire CAN network together using 18-20 AWG. Ensure every component connected to the CAN network is connected in between
the two (2) end components that have CAN termination. Please refer to the BLUE, GREEN, and BLACK lines as the CAN wires below.
Before continuing, use the EXM Configuration Tool manual P/N 98510000 to configure the EXM system.
18g
oo oo oo oo oo oo oo ooooooo oo oo oo oo oo ooo
ooo oo oo
oo oo oo oo oooooooo oo oo oo
oo oo oooo
7/32” dia.
unless noted 10-24 x 5/8”
for