Elkhart Brass ELKHART 294-11-CWB User Manual
Page 5
Figure 1
Improper Flange Installation
3.
Chain Installation on monitor (0.250” non-magnetic aluminum chain required,
McMaster Carr part number 3620T21)
a) Vertical movement
(1) Remove spring clip (item #12 on attached drawing) P/N 57681
(2) Slide chain wheel guide off shaft
(3) Find middle point on length chain and hang onto the Chainwheel
(4) Slide chain wheel guide back onto shaft
(5) Reinstall spring clip
b) Horizontal movement
(1) Repeat above steps 1-5
4.
Install model 282B stream shaper (if provided) onto monitor discharge. Tighten with spanner
wrench
5.
Install model CJ-B-RC or CJN-B-RC onto 282B or monitor discharge with the slotted boss on
the body centered on the underside of the nozzle when the monitor’s discharge is at the 90
degree angle to the water supply piping. Tighten with spanner wrench