Elkhart Brass Scorpion 8394-04 - Manual (Page 14)

11
5. 81466001 Auxiliary Battery
¾ Mark locations of mounting holes on mounting surface or bracket per Figure 13
¾ Drill four (4) 21/64" diameter mounting holes.
¾ Open hinged cover of battery enclosure by loosening the four screws. Insert one
5/16-18 UNC socket head cap screw from the inside of the enclosure through each of
the four (4) mounting holes of the enclosure and into the corresponding holes in the
mounting surface or bracket. Assemble nuts and lock washers to each mounting
screw then tighten.
Figure 13
Auxiliary Battery Mounting Hole Pattern
6. 81242001 Receptacle for Optional Hand-Held Control
¾ Mark locations of mounting holes on mounting surface or bracket per Figure 14
¾ Cut 2.0” diameter clearance hole and drill, (4) 3/16" diameter, mounting holes.
¾ Insert Packard connector and harness through clearance hole. Align escutcheon plate
screw holes with the mounting holes and secure panel with four #8-32 self-tapping
screws.
Figure 14
81242001 Receptacle for Optional Hand-Held Control