Elkhart Brass Sidewinder 8494 MOTOR ASSEMBLY - Manual (Page 2)

holes in the mounting pad on the monitor. Check that the rubber gasket on the motor assembly
has remained in the correct position then carefully push the motor assembly towards the
monitor, making sure the alignment pins engage the holes in the mounting pad on the monitor.
8) Reinstall the 4 motor screws and any wire harness clamps in their original positions. The
screws should be secured with #242 Loctite. The screws should be tightened evenly in a
crisscross pattern, being sure that the motor squarely clamps the gasket tight against monitor
pad.
9) Reconnect the 2 position motor power plug to the monitor harness. Turn on system power and
test the replaced motor using the monitor controls.