Elkhart Brass 8294-01 Motor Replacement Kit - Manual

98406000 Rev-A
Elkhart Brass Mfg. Co. , Inc. 1302 W. Beardsley Avenue • Elkhart, Indiana 46514 • 1-574-295-8330 • 1-800-346-0250
www.elkhartbrass.com
8294-01 Motor Replacement Kit P/N 81453001
(Replaces motor P/N 46035001)
Assembly Instructions: Use general purpose petroleum based grease.
1. Grease Thrust Bearing (4) and place between Thrust Washers (3) before inserting them all into the
cavity in the Bushing (6).
2. Lightly grease O-ring (5) and place it in the outside groove on Bushing (6) and then install Bushing
washer/bearing/washer end first into Motor Assembly (1). Push it in until the O-ring can no longer be
seen and the Bushing contacts the bottom of the recess in the Motor Assembly.
3. Lightly grease O-ring (7) and place it in the outside groove on Gear Shaft (8). Align flats on shaft of
Motor Assembly and slot in end of Gear Shaft and then insert Gear Shaft into Bushing as far as
possible. The O-ring (7) should no longer be visible.
4. Remove original Worm from the old motor shaft. (This is the only part off of the original motor shaft that
will be reused.)
5. Assemble Woodruff Key (10), greased Worm , ½” thrust washer (9), greased ½” thrust bearing (10), and
½” thrust washer (9), Washer (11) onto Gear Shaft (8).
6. Insert O-ring (2) into face groove of Motor Assembly flange and install entire assembly into monitor
gear case making sure O-ring (2) stays in place.