Elkhart Brass SPIT-FIRE 8394053 Monitor - Manual (Page 4)

4
II. S YSTEM FEATURES AND C OMPONENT D ESCRIPTIONS
A. 8394053 Industrial Electric SPITFIRE® Monitor
CE C ERTIFIED TO ATEX 94/9/EC
All brass and stainless steel constructed monitor with vaned 4” water way. Powered
by two 120- VAC, 60-Hz., 1-phase, Synchronous Motors. Inlet of monitor is supplied
with 4”-150# flat face ANSI flanged base. Discharge of monitor is supplied with a
3.5-N. H. Threaded male outlet. Monitor stops are factory set at 346º (+173º to -173º
+from front center) horizontal and 135º (+90º to -45º) vertical movement. Monitor is
provided with a cat. #284-B Brass Stream Shaper, Satin Brass with 3.5-NH Threaded
outlet. Engagable override hand wheels are provided for manual vertical and
horizontal movements. Hand wheel will not rotate when monitor is operated
electrically. Monitor weight is approximately 300-lbs.
Monitor is rated at 200-PSI maximum working pressure and 2000-GPM maximum
flow.
ATEX certified Stainless Steel Motor Cable Junction Box with bracket to attach to
monitor flange base is included with monitor.
Monitor Motor features are:
 No brushes or arcing devices.
 Meets NEC (NFPA 70) Article 501 requirements for use in Class 1, Groups “A,B,
C & D,” Division-2 & Article 505 - Class I, Zone 2, AEx nA IIC T4 hazardous
location areas.
 Constant torque and current output in start, running, and stall.
 Will not cause damage or increase in current when motor is stalled.
 NEMA 4 (IP-67) rated.
 Instantaneous start, stop and reverse.
 Residual (Power Off) torque is always present.
 Long life and exceptional reliability.
WARNING : Do not take cover off the Vertical or Horizontal Monitor Motors. If cover
is/has been removed, the warranty is void and the service life of the motor is significantly reduced.
B. Industrial Electric Operated X-STREAM® Nozzles
 CE Certified to ATEX 94/9/EC(Group II, Category 3).
 All brass and stainless steel constructed nozzle with tip movement powered by a 120-VAC,
60-Hz., 1-phase Synchronous Motor. Supplied with 3.5” N. H. Threaded swivel inlet.
Engagable Override knob is provided for manual tip adjustment from straight stream to wide
fog.
Motor features are:
 No brushes or arcing devices. Meets NEC (NFPA 70) Article 501 requirements for use in
Class I, Groups “B, C & D,” Division-2 & Article 505 - Class I, Zone 2, AEx nA IIC T4
hazardous location areas.
 Constant torque and current output in start, running, and stall.
 Will not cause damage or current increase when motor is stalled.
 NEMA 4 (IP-67) rated.
 Instantaneous start, stop and reverse.
 Residual (Power Off) torque is always present.
 Long life and exceptional reliability.
Optional Nozzles are: