Elkhart Brass UBEC 3 to control an E4F or E6F actuated valve User Manual
Page 2
Programming; see section Xl, pages 53 -55 of the Unibody valve instruction manual.
You will need to program the unit;
To be a remote.
To reverse polarity (only if an E4F is used on an EB_J Jamesbury butterfly
valve.)
To change the pressure display units (if they want something other than PSI).
To change the flow display units (if they want something other than GPM).
2) After the UBEC3 has been programmed cycle the power to it and then transfer the
program from the UBEC3 controller to the E4F or E6F actuator using the instructions on
page 62 of the manual (see transfer code 4110) and then cycle power to the actuator.
3) After step 2 is complete auto calibrate the valve per the instructions in step 2 on page
63 of the manual.
Figure 1
Figure 2