Belkin F5D4071 - Manual (Page 10)

8
Configuration
8
Overview
The Adapter uses 56-bit DES encryption to block access from the outside. The
key is set by using the HomePlug Configuration Utility on the CD. By default, the
protection is enabled. However, it is recommended that you change the default
network password. All your HomePlug devices must use the same network password
in order for the computers to be networked. Make sure that all devices are loaded
with the same network password.
Diagnose Powerline Network
Part 1: Diagnose a Local HomePlug Device
Double-click the “Belkin HomePlug Utility” icon on your desktop to open
the utility shown in the screen below.
ardware Setup
The “Main” tab shows the HomePlug units that are connected to the current
computer and other devices on the network. It also tells you the MAC address of
each device. It lets you refresh the window, if you change devices, and also allows
you to connect to different networks if multiple units are connected to
your computer.
Note: If the link quality is poor, and appears red, or the MAC address of any of
the units connected to this computer appears to be all 0s, then you may have a
defective unit. Please contact technical support.