Englert S5-E Mini - Manual (Page 2)

Distributed by S-5! ® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. Visit the website at www.S-5.com for
complete information on patents and trademarks. For maximum holding strength, setscrews should
be tensioned and re-tensioned as the seam material compresses. Clamp setscrew tension should be
verified using a calibrated torque wrench between 160 and 180 inch pounds when used on 22ga steel,
and between 130 and 150 inch pounds for all other metals and thinner gauges of steel. Consult the S-5!
website at www.S-5.com for published data regarding holding strength.
Copyright 2011, Metal Roof Innovations, Ltd. S-5! products are patented protected.
S-5! aggressively protects its patents, trademarks and copyrights.
The strength of the S-5-E clamp is in its simple design.
The patented setscrews will slightly dimple the metal
seam material but will not puncture it—leaving roof
warranties intact.
S-5-E Mini Clamp
S-5-E Clamp
Please note: All measurements are rounded to
the second decimal place.
The S-5-E and S-5-E Mini clamps are each furnished with
the hardware shown to the right. Each box also includes
a bit tip for tightening setscrews using an electric screw
gun. A structural aluminum attachment clamp, the S-5-E
is compatible with most common metal roofing materials
excluding copper. All included hardware is stainless
steel. Please visit www.S-5.com for more information
including CAD details, metallurgical compatibilities and
specifications.
The S-5-E and S-5-E Mini have been tested for load-to-
failure results on a variety of double-folded standing
seam roofs, from leading manufacturers of panels and
panel-forming machines. The independent lab test
reports found on our website at www.S-5.com prove that
S-5! holding strength is unmatched in the industry.
Hardware shown is included with each clamp.
Example Profiles
For horizontal seams under
.5" crimp the seam to 180
degrees at desired clamp
location.
This illustration demonstrates crimp-
ing technique, NOT actual location
of clamp.
≤ .5”
Hardware shown is included with each clamp.
1.18"
(30.00 mm)
0.98"
(25.00 mm)
1.97"
(50.00 mm)
0.60"
(15.00 mm)
M10 holes
located 13.00 mm (0.50")
from edges of part
1.18"
(30.00 mm)
0.98"
(25.00 mm)
1.18"
(30.00 mm)
0.30"
(7.60 mm)
M8 hole
centered on part
0.35"
(8.90 mm)
0.30"
(7.60 mm)
0.35"
(8.90 mm)
0.60"
(15.00 mm)