Environmental Express Rotator - Manual (Page 11)

800.745.8218 / 843.576.1147 / www.environmentalexpress.com Environmental Express • 9
Heavy Duty LE Rotator: Operation and Instruction Manual Troubleshooting Your Rotator
The unit is plugged into the
wall outlet, the switch is on but
nothing happens. Is the wall outlet “hot”?
1. Check the breaker box and try plugging another electrical device into
the outlet to see if it works.
Does the switch on the unit light up? If not, the internal circuit breaker may
have tripped.
1. Try turning the switch off and back on to reset the circuit breaker.
2. If the switch illuminates, but the unit still does not operate, unplug
the unit immediately and call 1.843.576.1147 or 1.800.745.8218 for
technical support. Only a competent electrician should attempt to
work on the electronics of this unit. Failure to comply may void your
warranty.
The motor runs but the box does
not rotate. There could be several possibilities for this; stripped gears in the gearbox, a
broken chain, or loose set screws on pulleys are a few things to suspect.
If this problem has occurred, please contact technical support at 1.843.576.1147
or 1.800.745.8218. Please do not attempt to retrofit any components. (If your unit
is still under warranty, you may be entitled to parts at no expense to you.)
The unit makes noise while
rotating. After continued use over several years, it may be necessary to grease the two
bearings. This is a very simple process.
1. Unplug the unit, insert the grease gun fitting over the zerk nipple
located on the bottom of each flanged bearing.
2. Pump the grease gun until you notice a slight trace of grease discharge
out of the bearing insert.
This should correct the problem.
Heavy Duty LE Rotator Troubleshooting Guide: