ERICO CADDY ROD LOCK Strut - Manual (Page 2)

The end of the threaded rod
must be positioned at or
below bottom of locknut
M8 & M10, A25 & C15 Metric Struts, 550 mm - 1050 mm Span
www.erico.com
TECHNICAL SUPPORT:
2 OF 2
INSTRUCTION SHEET
CFS508_B
© 2014 ERICO International Corporation.
CADDY® ROD LOCK Strut
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
Hand tighten
bottom locknut
3
until reaches stopping position
Rotate locknut counter clockwise
1
Maximum Open Position
open end wrench
threaded rod.
to adjust height of
Rotate hex shaped
main housing with
24mm or 15/16"
4
2
Push threaded rod into
CADDY ROD LOCK device