ERICO CADDY SPEED LINK Riveted Accessories - Manual

"D"
0.5 x "D" = 60
<60°
0.85 x "D" = 60
<60°
CADDY
R
R
CADDY
R
CADDY
Locking Device
1.5mm
R
CADDY
Locking Device
2mm
"D"
KG/LB
KG/LB
KG/LB
Description
Load
KG LB
1.5mm wire/rope 20 44
2mm wire/rope 45 100
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com CFS465_D
INSTRUCTION SHEET
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 4 © 2012, 2013 ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any 6.
other purpose.
This product is for use in static load applications only. 7.
Do not exceed the static load limits stated in these instructions. 8.
Although the CADDY SPEED LINK locking device can be used with steel cable meeting the cable specifictions set forth below, the use of other manufacturer's 9.
products in conjunction with CADDY SPEED LINK voids all ERICO warranties and UL listings.
Use CADDY SPEED LINK only where steel cable does not come in contact with sharp, unguarded edges. 10.
CADDY SPEED LINK assembly shall be used only in a non-corrosive indoor environment. 11.
1.5mm stainless steel CADDY SPEED LINK assembly can be used in environments that are compatible with 304 stainless steel. The customer is responsible for 12.
determining the environmental suitability.
CADDY SPEED LINK Riveted Accessories
R