ERICO Universal Pedestal Clamp - Manual

MBNUPCJ82
MBNUPCJ240
UPCJ
1. Stranded conductors #8 - #2 AWG: 7 or 19 strands.
2. Solid Conductors: #2 AWG; Stranded Conductors: #2 AWG: 7 or 19 strands #1 - 4/0 AWG: 7, 19 or 37 strands
ANSI is a registered trademark of American National Standards Institute
UL is a registered trademark of UL LLC
Notes:
xMBNUPCJ82, MBNUPCJ240 & UPCJ are UL® Listed per UL 2239 for support of any combination of
UL® Listed CADDY® CAT LINKS J-hooks with a maximum total load rating of 50lbs.
xMBNUPCJ82 includes the MBNC82 ground clamp which is UL® Listed per ANSI®/UL 467
xMBNUPCJ240 includes the MBNC240 ground clamp which is UL® Listed per ANSI®/UL 467
Part Number
Pedestal Size
(Round or Square) Bonding Conductor
Conductor
Type
Load
Rating
MBNUPCJ82 7
8
" - 2" #8 AWG - #2 AWG
Solid, Stranded 1 50 lbs
MBNUPCJ240 7
8
" - 2" #2 AWG - 4/0 AWG
Solid, Stranded 2 50 lbs
UPCJ 7
8
" - 2" - - 50 lbs
CADDY, CADWELD, CRITEC, ERICO, ERITECH, ERIFLEX, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT
www.erico.com IP8170_G 1 OF 2
INSTRUCTION SHEET
Universal Pedestal Clamp
©2010, 2011, 2012 ERICO International
Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any 6.
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.