ERICO CSBIB - Structural Attachment Fitting, I-Beam Adapter - Manual

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
CFS389_C
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
TECHNICAL SUPPORT:
All governing codes and regulations and those required by the job site must be observed.
The customer is responsible for:
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
NFPA is a registered trademark of National Fire Protection Association.
© 2009 ERICO International Corporation
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
1 OF 2
other purpose.
UL is a registered trademark of Underwriters Laboratory, Inc.
6.
www.erico.com
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
INSTRUCTION SHEET
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
a. Conformance to all governing codes.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
CSBIB
STRUCTURAL ATTACHMENT FITTING
I - BEAM ADAPTER
DOWN
ALONG BEAM
ACROSS BEAM
SECTION VIEW FRONT VIEW
Sway Brace assemblies are intended to be installed in accordance with NFPA-13 and the
manufacturer's installation instructions.
The required type, number, and size of fasteners used for the structure attachment fitting
shall be in accordance with NFPA-13.
FM ® Load Rating
Across Beam Along Beam Down All Directions
INCH mm INCH mm lbs. (N) lbs. (N) lbs. (N) lbs. (N)
CSBIB075085(XX) 1/4 - 3/4 6 - 19 4 - 8.5 100 - 215 3740 (16635) 3740 (16635) 3740 (16635) 3900 (17345)
CSBIB075145(XX) 1/4 - 3/4 6 - 19 4 - 14.5 100 - 365 3740 (16635) 3740 (16635) 3740 (16635) 3900 (17345)
CSBIB125180(XX) 3/4 - 1-1/4 19 - 31 4 - 18 100 - 455 3740 (16635) 3740 (16635) 3740 (16635) 3900 (17345)
*(XX) = Finish Specifier
*Part Number
Flange Thickness Flange Width
UL ® Load Rating