ERICO CADWELD Cable to Stud insert - Manual

Stud
Shoulder
Tap Hole
Conductor
Weld Cavity
Prior to making a connection, read and follow the full instruction sheet:
IPP = Grounding applications
IPP & IPRNS = Rail properties
shipped with CADWELD mold and special instructions below.
2. Position Conductor in mold as shown and against stud.
Position Stud in weld cavity with shoulder of stud against graphite. This will 1.
properly position stud under center of tap hole.
TECHNICAL SUPPORT:
www.erico.com IP8269_A
INSTRUCTION SHEET
1 OF 1 © 2013 ERICO International Corporation
CADWELD ®
Cable to Stud insert
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.