ERICO IP6664 Type GF Special User Manual
ERICO Accessories for electrical
Sleeve
Gap as Shown on Mold Tag (See Step 3)
Gap (As Shown on Mold Tag)
Prior to making a connection, read and follow the full instruction sheets IPP, IPX,
IPRNS (included only with molds used on rail property not to rail) and the special
instructions below.
Position crown socket in mold as shown.
1.
Gap cable and crown socket under center of tap hole (see mold tag for gap).
2.
If no gap is required, butt cable and crown socket under center of tap hole.
3.
When using sleeve, let cable protrude .13” [3 mm] beyond end of sleeve.
4.
Note: End of crown socket must be cleaned. Use card cloth brush or rough file.
TECHNICAL SUPPORT:
www.erico.com
IP6664_D
INSTRUCTION SHEET
1 OF 1
© 1995, 2013, 2014
ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.