ERICO IP6778 Bus to Vertical Steel, Horizontal Tap on Edge User Manual
ERICO Accessories for electrical
Prior to making a connection, read and follow the full instruction sheet IPRNS, the full
instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX) and special
instructions below.
Mark bus (As shown under “A” in chart above) from end to be welded.
1.
Place mold on bus with side of mold bus. This will position end of bus .13” [3.2mm]
2.
back from center of mold (As shown above).
3. Clamp mold to steel.
Top View
Side View
.13" [3.2 mm]
"A"
®
CL
Mold Size
"A"
3" [76.2 mm]
1.38" [34.9 mm]
4" [101.6 mm]
1.88" [47.6 mm]
TECHNICAL SUPPORT:
www.erico.com
INSTRUCTION SHEET
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 1
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.
TECHNICAL SUPPORT:
www.erico.com
IP6778_C
INSTRUCTION SHEET
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.