ERICO IP8274 ERICO CADWELD Bus to Horizontal Steel, Tap Flat Style CG - Manual

Center line of
mold / tap hole
Tap hole
Steel surface
CADWELD Mold L160 Handle Clamp
Strip / Conductor
Shim Piece of Strip / Conductor
Prior to making a connection, read and follow the full instruction sheet (IPP & IPRNS)
shipped with CADWELD mold and special instructions below.
2. Material must be flat to keep from springing the mold.
3. The conductor ends should be centered under tap hole.
4. Lock mold halves with L160 Handle Clamp, making sure there are no gaps.Secure
5. Follow standard welding instructions.
1. From existing conductor stock, cut a 2 inch piece to sandwich in the mold as shown
as a shim piece.
mold to steel surface.
TECHNICAL SUPPORT
www.erico.com IP8274_A 1 OF 1
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
ERICO® CADWELD®
Bus to Horizontal Steel, Tap Flat
Style CG
© 2014 ERICO International Corporation.