ERICO ERIFLEX FLEXIBAR FLEXITOOLS - Manual (Page 2)

FLEXITOOLS
Operating Guide
Bending (Bending Tool No. 559150): Make
bends quickly and easily with no risk of
damaging the insulation. Clean neat bends that
can be reproduced time after time.
C1

Loosen pressure plate and slide
back away from work piece. Insert
FLEXIBAR to be bent.
C2

Adjust to desired length.
C3

Move pressure plate into contact
with workpiece.
C4

Tighten pressure plate in position.
C5

Tighten jaws on bending clamp.
C6

Pull up on swivel-release knob.
C7

Using socket wrench as a handle, begin bending operation.
C8

Stop at desired angle.
Twisting-Changing Plane (Twisting Tool No.
559160): Easy operation with this exclusive
ERICO procedure that allows all the laminates to
move within the insulated sleeve. After forming,
the ends should be trimmed with the cutter.
D1

Open Twisting tool as shown in
D8 and gently tighten onto
workpiece.
D2

Adjust to length desired.
D3

Begin twisting.
D4

Stop at desired angle.
D5

Twist to desired angle.
D6

Begin twisting again.
D7

Stop at desired angle.
D8

Release twisting tool.
D9

Remove workpiece.
D10

Remove insulation as required.
D11

Chamfer edge.
D12

Completed FLEXIBAR