ERICO IP6647 Cable to Ground Wire User Manual

ERICO Accessories for electrical

Advertising
background image

Run Rod

"E-Z" Change Clamp

Prior to making a connection, read and follow the full instruction sheets IPP, IPX,

IPRNS (included only with molds used on rail property not to rail) and the special

instructions below.

Position mold on rod and cable

1.

Butt corner end of tap cable to top of run rod under center of tap hole (As

2.

shown above).

Do not shove cable past center of tap hole.

3.

TECHNICAL SUPPORT:

www.erico.com

IP6647_B

INSTRUCTION SHEET

1 OF 1

© 1995, 2014

ERICO International Corporation



WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.

All instructions must be completely followed to ensure proper and safe installation and performance.

3.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

Advertising
Table of contents