ERICO SIM Series 6m Stainless Steel Guyed Mast - Manual

INTCPT ADAPTER
(ERICO Part # INTCPTMIDYN)
ERICO DYNASPHERE
(ERICO Part # D/SMKIV-SS)
®
Detail "A"
Stainless Steel Mast
(ERICO Part # SIM28A2)
Bonding Clamp
(ERICO Part # TMCSS)
Stainless Steel Mast Base
(ERICO Part # SIMBASE2840)
Refer to Detail "B"
SIM28A2
SIMBASE2840
Detail "B"
4 HOLES, Ø11mm
200mm 170mm
1
-
®
Ground Inspection Well
Downconductor
Lightning Event Counter
(ERICO Part # LECIV)
ERICO CADWELD Connection
or mechanical connection
® ®
Minimum 16mm X 2.4m long
ground rod in four locations
Stainless Steel
Cable Tie
(ERICO Part # CABTIESS)
Three every 1m
Lightning Event Counter
Refer to installation manual
for alternate locations
(ERICO Part # LECIV)
Two downconductors
are required
Not to Scale
Downconductor
TMCSS Mast Clamp
Installing contractor to
field adjust and insure a
secure bond on highest
SIM series mast
Mast Detail
For complete
grounding system
refer to Detail "A"
Typical Conductor Connection
(ERICO Part # PDCUC) Tape Fasteners
(ERICO Part # TCEC253) Copper Tape
Not to Scale
2
-
Crow's Foot
(ERICO Part # GF302)
Preferred Angle
45° - 60°
Guy Kit
(ERICO Part # GUYKIT4M/GRIP)
Do not over-tension guy wires
(Slightly sagging)
Stainless Steel Mast
(ERICO Part # SIM33B2)
Stainless Steel Mast
(ERICO Part # SIM40C2)
SIM33B2
SIM40C2
2
-
1
-
Note: This is one of several alternative installation methods.
Refer to ERICO installation manual for more details.
Suggested triangular grounding system for each downconductor:
The grounding system shown in the detail is a suggested layout. Each radial consists of a trench
approximately 0.8m deep. The conductor is laid in the trench and is connected to ground rods. The
conductor in each trench is encased in GEM material. Ground rods must extend 3m below ground
level.
3m tape enclosed in
GEM material
TECHNICAL SUPPORT
www.erico.com IP79150_A 1 OF 1
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
ERICO DYNASPHERE MKIV
Installation Instructions for 6m Stainless Steel Guyed Mast - SIM Series
© 2014
ERICO International Corporation.