ERICO INTMKIV-SS - Manual

INSTRUCTION SHEET
WARNING
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO’s instructions and warnings may cause product malfunction, property damage, serious bodily injury and death.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the
application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of ERICO International Corporation
TECHNICAL SUPPORT:
www.erico.com HBCR1621_4 1 of 2

2009 ERICO International Corporation
INTMKIV-SS
ERITECH
®
INTERCEPTOR AIR TERMINAL
Recommended General Order of Installation
1. Full installation of the grounding system
2. Full installation of the downconductor
3. Termination of the downconductor to the grounding system
4. Connection of the ERITECH
®
INTERCEPTOR terminal to the downconductor
5. Termination of the bonding cable from the upper termination to the structure (if required)
6. Raise mast into position and secure
Note: This instruction sheet is designed to show the method of mounting the ERITECH INTERCEPTOR air terminal to the mast and
connecting the downconductor. For more detailed information and information concerning grounding systems and the termination of
downconductors to grounding systems please refer to the ERITECH
®
SYSTEM 3000 Installation Operating and Maintenance Manual,
available from your nearest ERICO supplier, or at www.erico.com
1. FOR FRP MAST WITH ERITECH
®
ERICORE
DOWNCONDUCTOR
You will need to have the following ERICO items:
• INTMKIV-SS Air Terminal
• INTCPT-ADBUTT – Connects terminal to
mast
METHOD:
a) Slide the Mast Butt Adaptor (INTCPT-
ADBUTT) over the bottom of the ERITECH
INTERCEPTOR finial.
b) Feed the downconductor through the FRP
mast.
c) Screw the ERITECH INTERCEPTOR onto
the upper termination of the ERITECH
ERICORE downconductor and secure in
place using the lock screw provided with
INTCPT-ADBUTT. (It is recommended that
some thread locking adhesive be applied to
the screw before insertion).
d) Insert the mast butt adaptor into the top of the
mast and raise into position.
FRP MAST
INTCPT-ADBUTT
MAST BUTT ADAPTOR
LOCK SCREW
ERITECH ERICORE
UPPER TERMINATION
INTMKIV-SS