ERICO LENTON Mid-Range Bar Threader - Manual (Page 2)

www.erico.com 2
WARNING
1. ERICO products shall be installed and used only as indicated in ERICO
product instruction sheets and training materials. Instruction sheets
are available at www.erico.com and from your ERICO customer
service representative.
2. ERICO products must never be used for a purpose other than the
purpose for which they were designed or in a manner that exceeds
specified load ratings.
3. All instructions must be completely followed to ensure proper and
safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to
completely follow ERICO’s instructions and warnings may cause
product malfunction, property damage, serious bodily injury and death.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached,
including their capability of safely accepting the loads imposed,
as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site
must be observed. Always use appropriate safety equipment such as
eye protection, hard hat, and gloves as appropriate to the application.
Uncrating the Machine ....................................................... 3 – 4
Electrical ..................................................................................... 5
Center Rings ........................................................................ 6 – 7
Add Oil ....................................................................................... 8
Change Control Key .......................................................... 9 – 10
Change Chasers and Holders .......................................... 11 – 15
Change Control Block .................................................... 16 – 18
Threading Operation ...................................................... 19 – 20
Checking Threads and Bar End Engagement ...................... 21
Maintenance ........................................................................... 22
Troubleshooting ..................................................................... 23
Operator Reference Chart ..................................................... 23
Table of Contents