Hardware setup, Connect cables, Congo light server – ETC Congo Light Server powered by Cobalt Setup Guide User Manual
Page 2: N o t e
E T C S e t u p G u i d e
Congo Light Server
Congo Light Server Setup Guide
Page 2 of 3
Electronic Theatre Controls, Inc.
Hardware Setup
Connect Cables
Step 1:
Attach the appropriate IEC power cord to the power connector, then to the IEC receptacle.
Step 2:
Connect any monitors to the proper ports on the back of the Light Server.
Step 3:
Connect the USB mouse and keyboard to the USB connectors.
Step 4:
Attach a network ethernet cable to the ethernet port.
Step 5:
Connect optional cables as desired including remote trigger, midi, DMX, and phone
remote.
Step 6:
When all connections are made, switch the hard power switch on.
Step 7:
Press the soft power switch, on the front of the unit, to power up the Light Server.
N o t e :
If the unit does not power up, check the rear panel to insure the hard power switch
is on.
100-240VAC
50/60 Hz
2A@120VAC
PUSH
ETC 2U Processor Unit
Electronic Theatre Controls, Inc.
Middleton, WI USA
Remote Trigger
C
US
3060167
www.etcconnect.comw
w
w
.e
tc
c
o
n
n
e
c
t.
c
o
m
DMX
1
DMX
2
Phone Remote
MIDI In
MIDI Out
PUSH
Hard Power Switch
DMX
x2
Phone
Remote
IEC Receptacle
Midi In
& Out
Remote
Trigger
USB
Ports
Ethernet Ports 1 & 2
DVI-I
Port
DVI-D
Port
Display
Port
USB
Ports
eSATA
Port
Audio Out
(Audio In
Reserved for
Future
Implementation)
USB
Ports
Display Port
Display Port
DVI-I Port
DVI-D Port
DVI
VGA
Yes
No
Yes
with Adapter
Yes
Yes
No
No
Yes
with Adapter
Yes
with Active
Adapter
Congo Light Server supports up to 2 monitors using the
following combinations:
Multitouch monitors need to be Windows 7 or 8 Compatible.
Physical
Port
Signal
Type