ETC Cobalt 10 and 20 Setup Guide - Manual (Page 2)

Page 2 of 2
3060167 2.0A Information Technology Equipment
Make sure to keep the vents clear of any obstructions.
Pour ne pas compromettre la protection contre les risques d’incendie, remplacer
par un fusible de même type et de mêmes caractéristiques nominales.
For continued protection against risk of fire, replace only with same type and
rating of fuse.
Before servicing Cobalt, you must switch off the power on the rear panel and
disconnect the power cord completely.
The USB ports cannot be used for charging devices such as cell phones.
For information about MIDI and Remote Trigger, please see the current Cobalt
User Manual / Help System.
Remote Trigger
Phone Remote Ethernet IEEE 802.3af
(compatible power
sourcing ports)
USB Ports
DMX512A /
RDM ports
MIDI Ports
(1x In, 1x Out)
IEC Power Input
Hard Power Switch
(I = on, O = off)
Desk Lamp
Desk Lamp Controls
Desk Lamp
Audio Line Out
(Audio Line In reserved
for future development)
Dual-Mode
Display Port
Outputs*
Setup Guide
This setup guide provides identification of the inputs and outputs on the Cobalt 10 and Cobalt 20
control desks as well as provides important information regarding initial setup and use. See the
reverse side for specific information regarding the Cobalt 20 control desk.
For information about specific control desk features, operation, configuration and servicing, please
reference the built-in help system provided in the Cobalt operating software. Alternatively, you can
download an electronic PDF of the Cobalt User Manual from www.etcconnect.com or purchase a printed
Cobalt User Manual, ordered separately from ETC Customer Service.
USB Port
* Cobalt ships with three ‘active’ Display Port-to-DVI adapters. If ‘passive’ adapters
are used, only two may be used at a single time. A third adapter must be an ‘active’
adapter. Displays using an ‘active’ adapter have a max resolution of 1920x1200.