ETC Source Four Mini Canopy and Track Mount - Manual

E T C I n s t a l l a t i o n G u i d e
Source Four Mini Canopy and Track Mount Kits
Source Four Mini Canopy and Track Page 1 of 2 Electronic Theatre Controls, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel +44 (0)20 8896 1000  Fax +44 (0)20 8896 2000
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel +39 (06) 32 111 683  Fax +44 (0)20 8752 8486
Holzkirchen, DE  Ohmstrasse 3, 83607 Holzkirchen, Germany  Tel +49 (80 24) 47 00-0  Fax +49 (80 24) 47 00-3 00
Hong Kong  Rm 1801, 18/F, Tower 1 Phase 1, Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong  Tel +852 2799 1220
Service: (Americas) [email protected]  (UK) [email protected]  (DE) [email protected]  (Asia) s[email protected]
Web: www.etcconnect.com  Copyright © 2013 ETC. All Rights Reserved.  Product information and specifications subject to change.
7063M2100  Rev A  Released 2013-05  ETC intends this document to be provided in its entirety.
Introduction
This guide illustrates the installation of the Canopy and Track Mount kits for the
Source Four Mini fixture. For additional information, see the Source Four Mini User
Manual that shipped with your fixture.
Canopy Installation Procedure
Step 1: Remove the mounting plate from the fixture by removing the two canopy
screws. (These screws will be needed for Step 6.)
Step 2: Using the mounting plate screws and washers, secure the mounting
plate to the electrical box, which is not included.
Step 3: Connect the ground wire from the wall and the copper ground braid from
the fixture to the mounting plate ground screw. This will allow the fixture
to hang from the ceiling while you complete the wiring.
Step 4: Connect your supply power wires to the lamp wiring. Black is the hot
wire, and White is the neutral wire. Use the included two-position Wagos.
Step 5: To determine the alignment of the canopy, orientate the fixture in the
direction it will be focused.
WARNING: TURN OFF POWER at main fuse or breaker box and verify
that the power is off before proceeding with installation.
Wiring must meet local and national codes.
Do not mount the fixture on or near combustible surfaces.
Do not operate the fixture without a lens installed.
Always hang the fixture with the color frame retaining clip in
the locked position.
Canopy Canopy
Ballast Ballast
Tape Tape
Mounting Plate Mounting Plate
Screws x2 Screws x2
Mounting Mounting
Plate Flat
Plate Flat
Washers x2
Washers x2 Black & Black &
White White
Wires Wires
Blue Blue
Wires
Wires
Ground Ground
Wire Wire
Mounting Mounting
Plate Plate
Nut Nut
Retainer Retainer
Collar Collar
Yoke Stop Bracket Yoke Stop Bracket
Retainer Collar Retainer Collar
Canopy Canopy
Screws x2
Screws x2