ETC Source Four CE MultiPAR - Manual (Page 8)

English
8 Source Four MultiPAR CE
Cleaning the reflector
Do not use glass or window cleaners on the reflector. Chemicals in the cleaners will harm the reflective coating.
Do not use paper towels or harsh materials to wipe the reflector. These materials can scratch the surface of the
reflector.
1.
Unplug the fixture before attempting to clean the reflector.
2.
Remove the lamp before attempting to clean the reflector.
3.
Remove the lens so you can access the reflector from the front of the fixture. See
Removing a lens
on page 6.
4.
Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton cloth. If this is sufficient to
remove dust, go to step 7. Otherwise, continue to step 5.
5.
Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and gently wipe the reflector.
6.
Remove any soapy water residue with a clean, soft, lint-free cotton cloth dampened with water.
7.
Reinstall a lens before using the fixture.
Adding hanging brackets and clamps to Source Four MultiPAR CE
N o t e : The hanging irons attach to the Source Four MultiPAR CE. The clamp is bolted to the other end
of the hanging iron and then secured to the hanging pipe.
1.
Loosen and remove the bolt and washer in the end casting.
2.
Attach the hanging iron to the Source Four MultiPAR CE with the bolts and washers provided. (
Figure 6
) Be
certain to attach the longer section of the hanging iron to the MultiPAR and the shorter section to the c-clamp.
3.
Make sure the smaller length of the hanging iron is secured over the MultiPAR fixture body when attaching it to
the unit.
4.
The clamp attaches the fixture to the mounting pipe.
5.
Tightly fasten the clamp to the yoke with the provided yoke bolt and lock washer.
6.
Place the clamp on mounting pipe, then tighten the pipe bolt to secure it.
7.
Tighten the pan screw to lock the fixture into position.
Figure 6