Briggs & Stratton MOWER - Manual (Page 26)

26
1 Daily Dipstick / left side of Engine Check level 1
2 Daily Radiator Reservoir Bottle Check level 1
3 Daily Hydraulic Tank Check level 1
4 Daily Fuel Tank Check level 1
5 Daily* Pre-Air Filter Inspect/Clean 1
6 Daily* Screenbox, Radiator Fins/ Rear Inspect/Clean 1
7 Weekly Height Adjustment Shaft Housings Grease, Lithium 12
8 Weekly Tires Check Pressure 4
9 Weekly Hardened Bushines/Deck Lift Arms Light Machine Oil 10
9100/600** Air Filter Element / Left side of Engine Inspect, Replace as Nec. 1
10 100 Fan Belt / Rear of Engine Inspect, Adjust 1
11 150** Drain Plug / Underneath Engine Change Oil 1
12 Monthly Front Axel - Rod Ends, King Pin.pivot Grease, Lithium 6
13 Monthly Radiator / Rear of Engine Check coolant level cold 1
14 Monthly Rear Lift Pivot / Above Rear Deck Grease, Lithium 2
15 Monthly Lift Shaft Bushings / Under Seat Grease, Lithium 1
16 200 Battery / Right Side of Engine Check Electrolyte 1
17 300** Canistor / Left Side of Engine Change Oil Filter 1
18 600 Rocker Arms / Top of Engine Check Valve Clearance 1
19 800 Fuel Filter / Left side of Engine Replace 1
20 Yearly Pedal Shaft Bushings / Behind Bumper Grease, Lithium 2
21 200*** Hydraulic filters (2)/RH shroud,steering Replace 2
22 200* Hydraulic Tank / To Left side of Engine Drain, Flush, Refill 1
23 Yearly Radiator, Engine Block Change Coolant 1
7.14—LUBRICATION
Fre- No.
Item quency Location Type of of
(Hrs.) Lubrication Places
Figure U shows the top view of the I-Trim
with guards removed. Lubricate your
tractor at the recommended locations and
intervals using proper lubricants so that
maximum service and long life of the
machine may be obtained.
Your I-Trim Mower maybe equiped with a
digital hour meter. This meter will display a
signal after 5 hours and every 25 hours
thereafter, recommending that you change
engine oil and lubricate the mower.
Before doing any work on
your machine, stop the
engine, remove the ignition
key and set parking brake.
GREASE - Lithium base
or equivalent
OIL - Light machine oil
SYMBOLS
FIGURE U
* More often as necessary
** Perform first maintenance operation after 50 hours. All subsequent maintenance
performed at this interval. Service more often when operating under heavy load or in high
termperature.
*** Perform first change of hydraulic filters at 25 hours. All subsequent replacements at
200 hours