ETC EchoConnect Cat5 Termination Tray - Manual

E T C ® I n s t a l l a t i o n G u i d e
Unison
®
EchoConnect Cat5 Termination Tray
EchoConnect Cat5 Termination Tray Installation Guide Page 1 of 2 Electronic Theatre Controls, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel +44 (0)20 8896 1000  Fax +44 (0)20 8896 2000
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel +39 (06) 32 111 683  Fax +44 (0) 20 8752 8486
Holzkirchen, DE

Ohmstrasse 3, 83607 Holzkirchen, Germany

Tel +49 (80 24) 47 00-0

Fax +49 (80 24) 47 00-3 00
Hong Kong  Rm 1801, 18/F, Tower 1 Phase 1, Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong  Tel +852 2799 1220  Fax +852 2799 9325
Service: (Americas) [email protected]

(UK) [email protected]

(DE) [email protected]

(Asia) [email protected]
Web: www.etcconnect.com  Copyright © 2014 ETC. All Rights Reserved.  Product information and specifications subject to change.
7186M2201  Rev A  Released 2014-05  ETC intends this document to be provided in its entirety.
Overview
This EchoConnect Cat5 termination tray is intended for
installation on the rear panel of the Echo Rack Mount
Station Power Supply (E-SPM-RM).
Use this termination tray to facilitate termination of up to
16 runs of Category 5 (or equivalent) cable on the
EchoConnect communication bus.
The following supplies are included for installation
convenience:
• 6.25” (15cm) of 2 conductor black/white wire
• 11” (28cm) ESD ground with Faston connector
• 4 x mounting screws
• Six position screw terminal connector J3263-F (x1)
Mount Tray to Rear Panel
The termination tray installs to the rear panel of the Echo
Rack Mount Station Power Supply. Secure the
termination tray to the rear panel using the four mounting screws provided.
Terminate Wires
This termination tray, as well as the rear panel of the Rack Mount Station Power Supply are provided
with wire forms to secure wires with cable ties. Cable ties are not provided but highly recommended to
use in maintaining the wire bundles.
Terminations include:
• EchoConnect between this termination tray and the Echo Rack Mount Station Power Supply.
• Up to 16 runs of Category 5 (or equivalent) cable between this termination tray and Echo control
stations.
• ESD ground wires terminate to the ground bar on the rear panel of the station power supply. This
connection is required for all stations that are not installed entirely in grounded metal conduit.
6.25” (15.8cm)
included
11” (28cm)
included
(16) Cat5 inputs
EchoConnect - white/black
twisted wire connects
between the 6 position
connector on the tray and
the 2 position connector on
the power supply.
ESD ground wire with Faston
connects between tray and ESD
ground bar on the power supply