ETC SmartPack CE Terminal Output Panel Setup Guide - Manual

E T C ® S e t u p G u i d e
SmartPack
®
with Terminal Output Panel
Americas „ 3030 Laura Lane, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA „ Tel: +608 831 4116 „ +800 688 4116 „ Fax: +608 836 1736 „ +800 555 8912
Europe „ Unit 5, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK „ Tel: +44 (0)20 8896 1000 „ Fax: +44 (0)20 8896 2000
Asia „ Room 605-606, Tower III Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong „ Tel: +852 2799 1220 „ Fax: +852 2799 9325
Web: www.etcconnect.com „ Email: (US) [email protected] „ (UK) [email protected] „ (Asia) [email protected]
Service: (US) [email protected] „ (UK) [email protected] „ (Asia) [email protected]
Comments about this document: „ Commentaires: „ Anmerkungen: „ Comentarios sobre este documento: [email protected]
Copyright © 2003 Electronic Theatre Controls, Inc.
All Rights Reserved. Product information and specifications subject to change.
Tous droits réservés. Toutes informations et spécifications techniques susceptibles d'être modifiées.
Alle Rechte vorbehalten. Bei Produkt Informationen und Eigenschaften sind Änderungen vorbehalten.
Todos derechos reservados. Información y especificaciones del producto sujetos a cambio.
7020M2210 „ Rev A „ 9/2003
This Setup Guide contains installation instructions for the SmartPack
®
with Terminal Output Panel. If you
have any questions, please contact the supplier of your ETC equipment or ETC Technical Services.
ETC Americas: Tel: +1 800 688 4116 (toll-free within USA)
Tel: +1 608 831 4116 (from outside USA)
Email: [email protected]
ETC Asia: Tel: +852 2799 1220
Email: [email protected]
ETC Europe: Tel: +44 (0)20 8896 1000
Email: [email protected]
Installation Instructions
Step 1: Terminate conductors.
a: To prepare the load conductors, strip 12-13mm (.49”) of insulation from the end of each wire.
To prepare the input conductors, strip 16-17mm (.65”) of insulation from the end of each wire.
b: Insert the Wago terminal tool (Wago #210-141) into the terminal (input terminal shown), or
you can use a screwdriver if the Wago tool is unavailable.
Model Number Voltage Model Number Voltage
SH615TM 230V SN615TM 230V ND
SH1210TM 230V SN1210TM 230V ND
- OR -