EZWatch EZBR-0519 - Manual (Page 3)

3
Qwik Install
STEP 1:
Choose a mounting location with good line of sight to the re-
mote location. The supplied bracket can be mounted to a wall or to an
existing pole up to 2” diameter. If only short distances are needed, the
antenna can be mounted inside a building.
TECH TIP: Microwaves travel in straight lines and they lose
strength quickly when going thru buildings and trees. If there are
objects in the microwave path, then useable distance will be reduced. If
the target unit is less than 1 mile away then you won’t have to worry too
much about a couple obstructions but if over 1 mile and there are some
obstructions in the microwave path, then the performance will be re-
duced.
STEP 2: Mount the Bracket
To mount to a wall: The supplied u-bolt is
not used and the bracket is screwed directly
to a wall using customer supplied screws.
To mount to a pole: Use the supplied U-Bolt
and wing nuts. Make sure to use a lock
washer at each wing nut. Tighten wing nuts
evenly by hand. Use pliers if additional tight-
ness is needed.
STEP 3:
Mount the antenna housing to the
bracket. Put the hex head bolt thru the housing
back fin. Put the star lock washer so it is be-
tween plastic housing and metal bracket. Install
wing nut with lock washer. Adjust desired tilt an-
gle and tighten wing nut. Use pliers if additional
tightness is needed.
TECH TIP: Because of the specially de-
signed wide beamwidth antenna, pointing is not criti-
cal and simply pointing in the general direction of the
receiving antenna will yield great results.
STEP 4:
Remove the antenna bottom cover by using a
coin or house key or screwdriver to push
in one of the side snaps and then remove
the cover.
STEP 5: Route a CAT5 cable through the