EZWatch EZ-TRACK-DOME - Manual (Page 3)

for more. Because of this, the camera will move in short bursts when it is set up in motion
tracking mode. A large amount of configuration is available for this mode, all of which is
detailed in the next section. Motion tracking mode is activated by calling preset number
80.
Camera Configuration & Setup
All configuration and setup for the camera is done within the camera menu. Accessing
the camera menu is done by setting preset 95.
Once in the menu, movement through the screens is done with the joystick. Tilting the
joystick up/down/left/right will move the cursor around. The ‘Iris Open’ key functions as
‘enter’, and the ‘Iris Close’ key functions as a cancel.
The Main camera Menu consists of 4 sub-sections and 4 functions. It also has an ‘exit’
option. Choosing the ‘Exit’ option, no matter which menu or section you are in, will
ALWAYS exit the menu entirely. The menu options are:
<System Information>
<Display Setup>
<Dome Settings 1>
<Dome Settings 2>
<Dome Label>
Reset Camera
Reboot System
Language
Exit
The first option, System Information, simply displays relevant information about the
camera. It displays the protocol, address, and baud rate of the unit as well as the
temperature of the unit. This is primarily used for the temperature, as the
protocol/address/baud rate can be seen when the unit is first powered on and the language
should be self-explanatory.
The second, third, and fourth options (Display Setup, Dome Settings 1, and Dome
Settings 2) are sub-menus which will be explained in further detail later.
Dome Label allows you to enter a name or label for this camera. This is primarily used to
identify the camera in situations where multiple EZ-TRACK units are being viewed
simultaneously. This section has two options – Edit Label, and Clear Label. The label is
normally displayed at the top center of the EZ-TRACK screen.
Resetting the camera will reset all menu options to their defaults, but does not erase any
stored presets or patterns.