Bakers Pride Rotisserie Ventless Hood VGH-Series - Manual (Page 8)

Rotisserie Ventless Hood Installation
6
Installation
Serious injury, equipment damage or death could result if attempting to install
this unit yourself. Ensure that an authorized BKI service agent installs the unit.
Unpacking and Handling
Inspection for Shipping Damage
YOU are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates
for damage as soon as they arrive. If damage to cartons or pallets is found, or if a shortage is found, note
this on the bill of lading (all copies) prior to signing and receiving.
If damage is found when the equipment is opened, immediately call the delivering truck line and follow up
the call with a written report indicating concealed damage to your shipment. Ask for an immediate
inspection of your concealed damage item. Packaging material MUST be retained to show the inspector
from the shipping line.
Location and Clearance
Make sure the rotisserie is mounted on a level surface capable of supporting the fully loaded oven. Refer
to oven installation guidelines in the oven manual.
The hood will be installed in one of two ways. New VGG’s may be ordered with the hood already
assembled (mounted to the top of the Rotisserie) or shipped with it for installation at the store location.
VGG’s already in service may be fitted with the hood at a store location as a retro-fit installation.
Disconnect VGG rotisserie from the electrical supply before attempting
installation. VGH-8 Hood for use only with BKI Models VGG-8 or VGG-16
rotisseries.
VGH-5 Hood for use only with BKI Model VGG-5 rotisserie.
Detailed Installation Instructions
1. Remove side panel on the control side of the VGG and both side panels on the VGH.
2. Unscrew the 4 philips head screws of the access plate on the ceiling of the VGG and turn it
around allowing hole to access the VGG control compartment. Reattach the plate with the 4
philips head screws.
3. Install the F0155 bushing provided into access hole of VGG.
4. Attach 1 of the FB68943018 (Appliance Lifting/Installation Bracket) handles on each side of
the VGH using the bottom two holes that the side panels attach to and with screws removed
from the side panels.
The hood lifting/installation brackets (FB68943018) are used as lifting
mechanism and are attached to the sides of the hood with side panels removed
for placing the hood on top of the oven. Failure to install this part could cause
damage to the hood and/or oven.
5. Pick up and place the VGH on the VGG making sure the controls are on the same side as the
VGG controls.