EZWatch EZWatchIP 4.0 User Manual
Page 7
Remote Playback configures your ability to watch previously
recorded clips from a remote location. Once again, if you cannot
use Port 80 you will need to change the Default Web Server Port
to 8000. Once the ports have been entered, Click on ‘Start’ to
activate the server.
3GPP configures your ability to watch the cameras remotely using
a cellular phone service. At the time this guide was created, no
cellular phone services in the United States currently offers 3GPP
support. Once 3GPP support is available then you will be able to
view the cameras remotely on a compatible device.
TIP :
To ensure that the Live Streaming server and the Remote Playback server both start up automatically
when you turn the Main Console on, click on Config, then Setting and place check marks in the boxes for both
Live Streaming Server, and Remote Playback Server. If these selections are not checked, then you will need to
turn the server on inside of the ‘Network Service’ window every time the software is restarted.
Step #8 How to access your camera system remotely using
the Remote View software. This section will give you a brief
overview of how to use the Remote View software to view
your cameras and to do desktop administration. You should
be at a remote computer or location for these steps.
Installation: The Remote View software can be found on
your EZ Watch Pro 4.0 installation CD. Insert the CD and
follow the directions to install the software. When it asks for
‘typical’ or ‘custom’ setup, choose ‘Custom’ and make
certain that Main Console is NOT selected. Follow the
prompts as they appear to continue with the installation.
Once the installation has been completed, click on Start,
open up ‘All Programs’, then open up the ‘EZ Watch Pro’
directory that appears there. Select the Remote Live Viewer
to open the Remote View software.
Once connected, you must first enter a new site to connect to.
At the bottom of the screen, click on the Wrench-and-Hammer
icon. It will pull up the Site Manager. Type the name of the site
you’re connecting to in the Server Name field. Enter your