Scarlett SC-1171 - Manual (Page 3)

www.scarlett-europe.com SC-1171 3
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read this instruction manual carefully before use and keep in a safe place for future reference. Incorrect
operation and improper handling can lead to malfunction of the appliance and injuries to the user. Before the first
connecting of the appliance check that voltage indicated on the rating label corresponds to the mains voltage in your
home.
· For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than described
in this instruction manual. Do not use outdoors. Always unplug the appliance from the power supply before cleaning
and when not in use. To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other
liquids. If it was happened DO NOT TOUCH the appliance, unplug it immediately and check in service center.
· Do not take this product into a bathroom or use near water. Do not place appliance or parts near an open flame,
cooking or other heating appliances. To reduce the risks of electric shock do not switch the appliance by wet hands.
· Close supervision is necessary when it is used near children. Do not leave the appliance switched on when not in use.
Do not use other attachments than those supplied. Do not attempt to repair, adjust or replace parts in the appliance.
Check and repair the malfunctioning appliance in the nearest service center only.
· Do not operate after malfunction or cord damage. Keep the cord away from sharp edges and hot surfaces. Do not pull,
twist, or wrap the power cord around appliance.
· Never insert fingers, pencils or any other object thorough the guard when the fan is operating. Do not operate without
fan grill properly installed.
ASSEMBLING INSTRUCTIONS
· Put the base on a level surface, insert the stand pole to the base and fasten it to the base with screws A..
· Turn the spinner clockwise and nut counter-clockwise and remove it from the motor. Mount the rear grille to the motor
by matching 2 holes on the rear grille and 2 pins on the motor housing. Push firmly until the 2 pins protrude through the
2 holes. Tighten the rear grille with nut firmly. Attach the blade so that the shaft pin is fully seated into the groove, in the
rear hub of the fan blade. Firmly tighten the blade by turning it counterclockwise. If spinner is not tightened properly,
abnormal sounds or even damage to the blade may occur. Mount the front guard onto rear guard by inserting upper
hook clip of the front guard over the rear guard. Secure with the clips on the front guard.
CAUTION:
· Do not plug the cord into the power supply until fan has been completely assembled.
· Never operate the fan with a cracked or damaged fan blade.
INSTRUCTION FOR USE
NOTE: To avoid the risk of electric shock or fire, do not use the fan at wet conditions (for example in rain).
· Always place the fan on dry and even stable surface.
SPEED CONTROL
· To switch on the fan, simply press any of the speed control buttons:
1 low airflow speed
2 medium airflow speed
3 high airflow speed
· To switch the fan off, press button.
OSCILLATION (PIC.1)
· There is an oscillation knob at the top of the motor housing. If you press the knob, the 90-degree turning mode will be
activated. If you pull the knob, turning mode will stop. Pull up this knob and the fan stops turning.
ADJUSTMENT OF THE AIR FLOW (PIC.2)
· The airflow can be adjusted upward or downward by simply moving the grilles up or down.
CARE AND CLEANING
· Always unplug the fan before cleaning. Do not use abrasive cleaners, gasoline, thinner or other chemicals to clean the
fan.
· To clean fan blade, simply lift the bottom clip of guards link and remove the front guard. Use a soft cloth, moistened
with a mild soap to clean grilles, fan blade.
STORAGE
· Keep the appliance in a cool, dry place.
· It is recommended to keep the original carton for after season storage.
RUS
· .
.
, ,
, .
· .
. .
, .
, . ,
,
. .
. .