Feiss P1305 User Manual
Freemont 1 light pendant, Installation instructions for, Use minimum 90°c supply conductors
1
Installation Instructions for
Freemont 1 Light Pendant
1.0
P1304-P1305
Pendant
P1304, P1305_
Align the shade with the frame, then insert the shade screws through the shade and the frame from the inside and secure them in
place by tightening with the knurled nuts.
Insert a bendable pin through the top of the frame and a decorative piece, then bend the pin into a hook like shape as shown on
drawing in order to securely hang the decorative piece; repeat for remaining decorative pieces.
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down.
Place the cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the end of
the wires. Note: Make sure not to nick the inner wires.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
1A
LAMP
FRAME
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized
esting aboratory”
N
R
T
L
This product is suitable for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
6
7
DECORATIVE PIECE
2
BENDABLE PIN
2
1
1
3
4
KNURLED NUT
SHADE SCREW
SHADE
CORD
CANOPY
CORD CLIP
CLIP SCREW
4
5
6
7