Before using clean&renew, Operating your clean&renew – Braun 7526 User Manual

Page 11

Advertising
background image

11

Before using Clean&Renew™

For the first charge of the shaver, connect the power
supply cord set directly to the shaver, charge it for
4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the
Clean&Renew™.

If the rechargeable batteries are discharged, select the
combined «clean + charge» program rather than the
«clean» program alone.

Installing the cartridge

Press the lift button (12) to open the housing.

Hold the cartridge down on a flat, stable surface
(e.g. table). Carefully remove the lid from the cartridge.
Slide the cartridge into the base as far as it will go.

Slowly close the housing by pushing it down until it
locks.

Replacing the cartridge

After having pressed the lift button to open the housing,
wait for a few seconds before removing the used car-
tridge.

Before discarding the used cartridge, make sure to
close the openings using the lid of the new cartridge,
since the used cartridge will contain contaminated
cleaning solution.

Operating your Clean&Renew™

Use the power supply cord set from your shaver and
plug it into the Clean&Renew™ and then into a main
outlet.
Open the contact bow (13) by pressing the release
button (14). After shaving, switch the shaver off and
place it upside down into the Clean&Renew™
(without having released the shaver foil).

Select the operation mode by toggling with the
mode selector (15):
clean

(about 15 min)

clean + charge

(about 75 min)

charge

(about 60 min)

The corresponding lights will come on.
(With cord shavers, only the «clean» function can be
selected.)

2

1

old

new

new

7526

a

u

to

m

a

tic

lo

ck

3

2

1

0

on/o

ff

cle

an

ch

arg

e

car

trid

ge

7526

a

u

to

m

a

tic

lo

ck

3

2

1

0

7526

5493310_S.4-38.fm Seite 11 Donnerstag, 12. Mai 2005 2:18 14

Advertising