Flex TPO Low VOC Bonding Adhesive - Manual (Page 3)

___________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533
Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com
Page 3
Note: Permeation-resistant gloves are recommended to be worn when using this product to
protect hands from irritating ingredients.
7. Do not thin Flex TPO Low-VOC Bonding Adhesive. Thinning will affect performance.
Excessively thick or gelled material should be discarded.
8. Job site storage in excess of 90ºF (32ºC) may affect product shelf life. Should the Flex TPO Low-
VOC Bonding Adhesive be stored at temperatures lower than 60ºF (15ºC), restore to room
temperature prior to use.
9. Opened containers of Flex TPO Low-VOC Bonding Adhesive should be used within 48 hours.
Adhesives will begin to thicken after this point, making it difficult and eventually impossible, to
control applied thickness. In hot weather, do not leave sealed containers on roof for prolonged
periods of time. In cold weather, keep material at room temperature until ready to use. Stir
adhesive occasionally while using.
10. KEEP OUT OF THE REACH OF CHILDREN.
This product is approved for use by Flex authorized applicators only and is for use in Flex TPO
Membrane roofing installations.
*
Physical properties. Typical properties and characteristics are based on samples tested and are not
guaranteed for all samples of this product.
** REVIEW CURRENT FLEX SPECIFICATIONS AND DETAILS FOR SPECIFIC
APPLICATION REQUIREMENTS.